Bell Tech Rear Axle Flip Kits & C-Section Kits
June 23, 2010 | Filed Under Uncategorized | No Comments
Lowering the back of a truck is almost always easier than lowering the front. With a typical straight rear axle, you can get lowering kits to get the truck down in the weeds. Swing hangers and more radical suspension changes will get you there. You can also flip the axle on top of your rear leaf springs which gains you a ton of drop. You can use spacer blocks between the axle and leaf springs to lower it more. One big problem that you soon will encounter on a radically lowered truck is the available travel between the axle and frame rails. Bell Tech makes kits to C-Section your frame rails to give more room for the suspension to collapse. Otherwise your rear end will slap the frame rails when it compresses. Bell Tech C-Section kits are purpose built to fit a specific truck. They bolt on so no welding is needed.
Leave a Comment
If you would like to make a comment, please fill out the form below.
You must be logged in to post a comment.